Gt14 mower deck

[Mark siebenaler 87]

First off I'm in mn and looking for a deck for a Gt14  will any b or c series deck work?

 

[953 nut 55,152]

If you add a Mule Drive to the front of the GT-14 you can use any newer deck. The receiver for the mule drive is used to retain the front axle of later model Wheel Horses. Lincoln at A-Z should be able to fix you up, give him a call.  https://www.a-ztractor.com/

Edited Tuesday at 09:59 PM by 953 nut
add photo

[Mark siebenaler 87]

Okay.  ? Do I need to install something 

On the tractor to accept  the mule drive. 

 

 

[gt14rider 750]

You will need to modify the front attach o matic, off set about a inch. The gt14 is wider than other tractors. If you need measurements let me know. 

Edited 15 hours ago by gt14rider

[peter lena 8,597]

@Mark siebenaler  just a suggestion , while you are right there , cleaned out and repacked those bearings with , lucas green HD chassis grease , why ?????   550 deg flash point , also polyurea  (  anti sling ) rating , talk about smooth quiet ,  never did your set up , but if they are 6203 ( 3/4 )  ID  bearings , the wide rubber side grease shields , carefully  remove , small flat putty knife or flat pocket screwdriver . clean out , flush with  carb cleaner , wipe dry , repack , reinstall seals , lay it out as you disassemble , vital to function correctly , might even do a similar detail function , on the PTO LEVER  FUNCTION , start point next to battery, like this  often refer to this area as a gold mine for improvements , my 3  PTO LEVER DRIVES , WORK  AMAZINGLY  SMOOTH / EASY , ALSO EASY TO DO , PETE  

 

[953 nut 55,152]

23 hours ago, Mark siebenaler said:

Do I need to install something 

On the tractor to accept  the mule drive.

Yes, the receiver for the mule drive can be salvaged from any late model parts tractor. A-Z can fix you up.