cod 120 #1 Posted September 20 Any suggestions on a "kit" for cleaning the electrical connectors on the wiring harness? There's a spray cleaner and I've used a small brass brush on male connectors but it would be better (for me) to not have to wind sandpaper into tiny rolls and scrub away. Thanks! Share this post Link to post Share on other sites
953 nut 55,394 #2 Posted September 20 Small Acid Brushes work well. https://www.harborfreight.com/12-in-horsehair-bristle-acid-shop-brushes-36-piece-61880.html?event_id=183642&utm_source=google&utm_medium=cpc&utm_campaign=12169631175&campaignid=12169631175&utm_content=114847946057&adsetid=114847946057&product=61880&store=3347&gad_source=4&gclid=Cj0KCQjwurS3BhCGARIsADdUH50SU0Di9wS4mauzxGbknyM6boYPgNdNbmto5-W--FrNCry3ZaOVdhgaAouMEALw_wcB 3 Share this post Link to post Share on other sites
ebinmaine 67,768 #3 Posted September 21 I've used a powered or manual wire brush to clean the terminals I have good access to. Female terminals can be a challenge. I've stuffed sandpaper and cleaned them up. Maybe use an emery board type fingernail file? We aren't doing factory correct restorations here. All our tractors (and other machines) are workers. If I have ANY doubt about the long term usability of a terminal I snip/toss/replace. Share this post Link to post Share on other sites