powderfinger 24 #1 Posted September 15 Hey Guys, My battery shows 12V on the multimeter but wont turn over. Where should I begin. Thanks to all! Share this post Link to post Share on other sites
pfrederi 17,700 #2 Posted September 15 Load test the battery. 12.0 volts is only 25% charged 12.6 full charge. 2 Share this post Link to post Share on other sites
squonk 41,051 #3 Posted September 15 After verifying the battery is good and fully charged, See how much the voltage drops with the key in the crank position. if it drops more than a couple of volts start looking for a bad or dirty battery cable. also make sure the ground connection at the engine block is clean too. it takes around 65 amps to crank a little 8 horse with a starter /gen 1 Share this post Link to post Share on other sites
powderfinger 24 #4 Posted September 15 5 hours ago, pfrederi said: Load test the battery. 12.0 volts is only 25% charged 12.6 full charge. Can I load test it with my multi meter? Share this post Link to post Share on other sites
953 nut 55,163 #5 Posted September 15 1 hour ago, powderfinger said: Can I load test it with my multi meter? Take it to an auto parts store to have it checked. 1 Share this post Link to post Share on other sites
powderfinger 24 #6 Posted September 15 Is that on your shop wall? lol 1 Share this post Link to post Share on other sites
peter lena 8,604 #7 Posted October 21 @powderfinger spell check on your internet , will correct TUEN , TO TURN OVER , pete Share this post Link to post Share on other sites
