856 addict 2 #1 Posted September 10 Quick question gentlemen. Is the points plunger on a k181 shorter than on a k301? I’m converting a breakerless 301 to points and I had a plunger out of a 181 I thought I could use but it’s too short. When I looked on isavetractors they just have one size for all k series. Just for reference I’m about 1/4” too short. Thanks fellas Share this post Link to post Share on other sites
gwest_ca-(File Mod) 11,070 #2 Posted September 11 I think the length is 1-1/2" but could be wrong. There was a fellow that built Kohler engines and had a ton of info on his website. That is where I saw it but can not find now. Pulling Tractor may have been the name. Anyone know where to find it? 1 Share this post Link to post Share on other sites
gwest_ca-(File Mod) 11,070 #3 Posted September 11 Found it. 1-1/2" is correct. https://gardentractorpullingtips.com/a1ign.htm Scroll down the page a bit. 1 3 Share this post Link to post Share on other sites
856 addict 2 #4 Posted September 11 Thank you so much! Share this post Link to post Share on other sites
