Toro 5618 E-RING holds my C-100 axle in place.

[Kelsey 91]

Greetings,

What size do I need from the local hardware store for

a Toro 5618 E-ring? Holds the front axle in place for my C-100.

Thanks,

Kelsey

[ebinmaine 67,420]

That should be a 3/4 or .750 inch diameter pin.

[Kelsey 91]

7 minutes ago, Kelsey said:

Greetings,

What size do I need from the local hardware store for

a Toro 5618 E-ring? Holds the front axle in place for my C-100.

Thanks,

Kelsey

 

24 minutes ago, ebinmaine said:

That should be a 3/4 or .750 inch diameter pin.

Thank you!

 

[Handy Don 12,212]

55 minutes ago, Kelsey said:

 

1 hour ago, ebinmaine said:

That should be a 3/4 or .750 inch diameter pin.

Thank you!

Get the heavy duty one, if you can. Wider flanges.

[953 nut 55,188]

Also, the ring is stamped, one edge is sharp and the other edge is somewhat rounded, put the rounded side toward the axle so the sharp edge will bite into the shaft when pressure is applied by axle movement.

[Kelsey 91]

Any installation tips for the clip?

[rmaynard 15,434]

If you use an e-clip, just snap it in place, but I recommend a retaining ring.

and install it with these pliers

Edited June 27 by rmaynard