Jump to content
tractorboy79

Gt14 clevis question

Recommended Posts

tractorboy79
Posted (edited)

Hello, I have a gt14 and a old brinly cultivator but I need the correct hitch to put on my tractor (clevis hitch) would clevis hitch fit on the back of a gt14 the same way as a another tractor or will I need to make adjustments? Anything helps? thanks!

Edited by tractorboy79
Misspelled brinly

Share this post


Link to post
Share on other sites
 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Similar Content

    • bob54
      By bob54
      How do I get this pin out,  I've tried heat, rust penetrate, and an air hammer, and just rust penetrate and the air hammer.    I can't get it to move, no matter what I do,,and yes I removed the clips from both ends.  I knew you were thinking about that



    • scotty
      By scotty
      My hitch pin is stuck in my b-80. I was wondering if i were to use my torches where would be the best place to heat it. I was reading someone said not to heat the pin. But if you heated the case wouldnt it end up hurting the transmission split gasket?
    • Ed Kennell
      By Ed Kennell
      The 520H snow blower project is finished waiting for snow and the MTD 700 is cleaned and oiled and actually mowed the lawn Sat.
       
      So, today was the Commando's turn.
       
                                                                       This I what I started with.  It actually runs and drives.
                                                                                
                                                                        After about 2 hours, I had this.
                                                                                
                                                                        An hour later
                                                                                
                                                                        Some of the crud I found
                                                                                
       
                                                                                
       
                                                                                
       
      Wonder how long it's been since this horse saw some maintenance. Hard to believe it could actually run in this condition.
                                                                                
                                                                                

    • redsquarebob
      By redsquarebob
      how would you get the pin out of the transmission where your hitch is its all set up any ideas how to get it out? i was gunna heat it but i dont think that would be good for the transmission.
    • Old Ways
      By Old Ways
      I'm going out of my mind trying to get this thing out. I took the trans out of my Commando 8, so that I could get to the pin for the hitch. Today I cut one side of the pin short then started to drill it out, and on my 3rd bit size up, it gets snagged, throws the trans over and snaps the bit inside the hole! I have tried everything, Heat & Hammer, large pipe wrench & pipe for leverage, drilling, pneumatic hammer, what am I doing wrong? I am about to just smash this thing with a hammer and throw it in the pond. Any help would be appreciated.
×
×
  • Create New...