JWog23 16 #1 Posted September 18, 2023 After a few years the 416h made it back. Looking forward to fixing it up 4 2 Share this post Link to post Share on other sites
Pullstart 62,902 #2 Posted September 18, 2023 Nice! Is there a back story? 1 Share this post Link to post Share on other sites
JWog23 16 #4 Posted September 18, 2023 5 hours ago, Pullstart said: Nice! Is there a back story? This machine was my first real introduction to wheel horse. My father in law had basically given it to me 15+ years ago. We lived next door on a piece of the families property the my wife and I acquired her parents. We were young and in a hurry to put a house on the property, so we went with what we thought was going to be a good investment, a prefab home. That was Not a good investment and not one of my Best decisions in life. The house was riddled with issues ( typical prefab problems ) along with other financial woahs So instead of keeping it we let it go back to the bank, the mower got left behind at my father in laws. It was a tough pill to swallow. That has been four years now almost to the month. I was selling the 520 and my father in law bought that machine from me and brought over the 416. More then a back story then you probably wanted to hear lol 😆 and I had to be vulnerable about it because it well... Is a bit embarrassing, but this has been my life ups, downs and everything in between. I know the 416 won't look as pretty as the 520 I had but it is more of a example of what my Life has been. Thanks Pullstart and ebinmaine ☺️ 3 Share this post Link to post Share on other sites
JWog23 16 #6 Posted September 18, 2023 17 minutes ago, SylvanLakeWH said: Thank You. I'm glad I found you folks 😁 2 Share this post Link to post Share on other sites
Sparky-(Admin) 21,318 #7 Posted September 18, 2023 New seat and get the mechanicals straight is all it needs right now. Worry about paint and decals down the road. Good luck with it 2 Share this post Link to post Share on other sites
lynnmor 7,307 #8 Posted September 18, 2023 Spray penetrating oil on all fasteners whenever you walk past it, this is especially needed on ALL of the Onan fasteners. Ask me how I know. 1 Share this post Link to post Share on other sites
ebinmaine 67,534 #9 Posted September 18, 2023 7 minutes ago, lynnmor said: Spray penetrating oil on all fasteners whenever you walk past it, this is especially needed on ALL of the Onan fasteners. Ask me how I know. That's excellent advice. I would also add that you should try to TIGHTEN every bolt before you loosen it. Just a tiny bit. Share this post Link to post Share on other sites
