rmaynard 15,588 #1 Posted June 13, 2023 At the point where I'm starting to assemble the 701 to hopefully have it ready for the show. Tried to move the transmission pulley to align it with the engine and... Put it on with never-seize so this wouldn't happen. Anybody have one they can send me and I'll pick one up at the show and return it with postage added. As you can see, the 701 project is dead in the water. 5 Share this post Link to post Share on other sites
Pullstart 63,081 #2 Posted June 13, 2023 If nobody chimes in by tomorrow morning Bob, I’ll go pop one off a runner if I have to. 2 1 1 Share this post Link to post Share on other sites
Achto 27,747 #3 Posted June 13, 2023 49 minutes ago, rmaynard said: Anybody have one they can send me and I'll pick one up at the show and return it with postage added. Could you grab one from a local hardware store in steel or aluminum? Paint it red to get the tractor to the show, swap it out for a correct one later. Just a thought. 3 1 Share this post Link to post Share on other sites
rmaynard 15,588 #4 Posted June 13, 2023 2 minutes ago, Achto said: Could you grab one from a local hardware store in steel or aluminum? Paint it red to get the tractor to the show, swap it out for a correct one later. Just a thought. I'm searching. No luck yet. 1 1 Share this post Link to post Share on other sites
squonk 41,309 #5 Posted June 13, 2023 (edited) I have an electrical motor supply shop up the road. They probably have one if you give me shaft od and pulley od. There's also Grainger and McMaster Carr. You'll have one Thursday Edited June 13, 2023 by squonk Share this post Link to post Share on other sites
rmaynard 15,588 #6 Posted June 13, 2023 McMaster and Grainger don't have an exact match. However, Todd (Redman) has one for me. Picking up tomorrow. Thanks for all the help. 3 1 Share this post Link to post Share on other sites
c-series don 8,810 #7 Posted June 14, 2023 It never fails to amaze me how nice people here are to each other!👍🏻 4 Share this post Link to post Share on other sites
Wheel-N-It 2,969 #8 Posted June 14, 2023 Bob, I was just reading through this and was thinking if I could find the aluminum one I had on my 701 before purchasing an original pully, I would bring it to you at the show. But now I see you should be picking up what you need tomorrow. Anyway, If that does not work out then PM me and I will do my best to find the one I have that will work in a pinch. Van 1 1 Share this post Link to post Share on other sites
Retired Wrencher 5,505 #9 Posted June 14, 2023 Bob hope all works out for you. I hope you enjoy the show. Enjoy the ride! Share this post Link to post Share on other sites
