Morganic 22 #1 Posted March 20, 2023 Anyone know if the bolts holding the solenoid switch to chassis on C125 have captive nuts? Going to change mine but don’t want to create a big job! Thanks 1 Share this post Link to post Share on other sites
ineedanother 1,369 #2 Posted March 20, 2023 (edited) Yep. They thread into the shroud. But chassis? I'm not sure what you mean by that. Edited March 20, 2023 by ineedanother Share this post Link to post Share on other sites
Mike in NC 341 #3 Posted March 21, 2023 (edited) The starter solenoid on m, Bronco 14 is on the chassis, side of dash tower. Not saying that is the original location. Edited March 21, 2023 by Mike in NC Share this post Link to post Share on other sites
Morganic 22 #4 Posted March 21, 2023 Thanks guys. I was afraid nuts would drop off and I’d have to remove panel that held solenoid. 1 Share this post Link to post Share on other sites
Morganic 22 #5 Posted March 23, 2023 The nuts are not captive but I managed to get them off and on again. 10mm bolt-11mm nuts !!! 3 Share this post Link to post Share on other sites
oliver2-44 9,756 #6 Posted March 23, 2023 Poor Horse, What kind of PO put metric hardware on a C125 1 Share this post Link to post Share on other sites
