Wheel horse tractor 312a question

[gris71 12]

I have a wheel horse 312a I think the  clutch plates are bad in the pto off the side of the motor it starts to run the mower deck belt then stops it is getting hot I think the clutch plates are bad. is there a parts breakdown for the clutch or dose anyone know the part number thanks for your help

[Sparky-(Admin) 21,315]

Almost sounds like you have some slippage. Is the clutch adjusted so when it’s engaged the bell is tight up against it?  
 Take a scroll thru the manuals section, I’m sure we have yours in here.

    https://www.wheelhorseforum.com/files/category/31-1985-1990/

[gris71 12]

I dont know how to adjust the clutch 

[Sparky-(Admin) 21,315]

1 hour ago, gris71 said:

I dont know how to adjust the clutch 

You add tension by turning this trunion, closer to the PTO handle, a little bit at a time. 
 

[peter lena 8,623]

@gris71 question , how easily can you move that drive belt by hand?  tractor shut off , key in pocket ,collective attachment  drag , from  related bearings , grass build up under deck  , as well as clutch adjustment can add up to very heavy belt drag . the easier it all spins up by hand , should be easy for the drive belt to move it , pete

[wallfish 16,995]

Also inspect this area and the bracket. There should be a pin holding it on which is common to fail after 30-40 years. If it's not attached correctly you can't adjust enough.

Post a pic of yours so we can see it