Need part # for input shaft needle bearing 36" tiller

[jeepdan 321]

Can someone give me the Torrington bearing number for the 3/4" input shaft bearing behind the seal?

 

[ri702bill 8,296]

IF it measures 3/4" ID x 1" OD and is 3/4" long.... then it is the same as those in the old gear drive rotary mowers ...P/N B1212. Do check first....

Also - if it is a genuine Torrington item, the number is stamped in on one of the rolled edges.

Bill

 

[jeepdan 321]

15 hours ago, ri702bill said:

IF it measures 3/4" ID x 1" OD and is 3/4" long.... then it is the same as those in the old gear drive rotary mowers ...P/N B1212. Do check first....

Also - if it is a genuine Torrington item, the number is stamped in on one of the rolled edges.

Bill

 

Thanks, But.......

Last summer, I tore down my tiller, did a thorough cleaning, and repainted all of the parts. I carried that particular bearing into the house so that I could order a new one.

Well, Spring is coming, the tiller is still apart, just now ordering bearings and case gasket, and, I have lost the old bearing.

Edited February 17, 2023 by jeepdan

[jeepdan 321]

OK,

Finally found the old bearing that I had removed. LOL

It is a Torrington B-128  3/4IDx 1" ODx 1/2" long.

Thanks again for the reply.

Dan

Edited February 17, 2023 by jeepdan

[c-series don 8,676]

@jeepdanOkay, you do know that we’d love pictures of that restored tiller! Especially in action, and don’t forget those new decals!! 

[jeepdan 321]

4 hours ago, c-series don said:

@jeepdanOkay, you do know that we’d love pictures of that restored tiller! Especially in action, and don’t forget those new decals!! 

I will. Thanks