horseyheaven 112 #1 Posted November 8, 2022 Hi everyone, I am rebuilding a hydraulic lift cylinder for my 520h. I need the snap ring that holds the piston in the bore. Mine snapped into many pieces while taking it apart. The cylinder measured 1.51” but I could not get a good measure down in the groove. I am guessing 1 9/16” or 1 5/8”. I can’t find a part number or size on any of the parts sites. I thought some of you may have ran into this before. Thanks everyone and have a good evening. Will 2 Share this post Link to post Share on other sites
953 nut 55,121 #2 Posted November 8, 2022 Just take the cylinder and your snap ring pliers to Ace Hardwar or Napa and they will help you out. Be sure to install the snap ring with the square cut side out, the other side is slightly rounded and won't hold as well. 4 1 Share this post Link to post Share on other sites
lynnmor 7,302 #3 Posted November 8, 2022 My kit includes the snap ring. 6 Share this post Link to post Share on other sites
Bill D 1,915 #4 Posted November 8, 2022 10 hours ago, lynnmor said: My kit includes the snap ring. Do you use Viton or Buna o-rings in your kits? Which is better for hydraulics and why? 1 Share this post Link to post Share on other sites
Jose 11 #5 Posted December 27, 2022 Hey guys question, where can I buy this kit for my 520 H? 1 Share this post Link to post Share on other sites
Jose 11 #6 Posted December 27, 2022 Hey guys question, where can I buy this kit for my 520 H? Share this post Link to post Share on other sites
953 nut 55,121 #7 Posted December 27, 2022 5 minutes ago, Jose said: Hey guys question, where can I buy this kit for my 520 H? @lynnmor will fix you up if you send him a PM. Click on the little envelope looking thing on the top right of the home page and type in his name and the "O" ring set as subject. 1 Share this post Link to post Share on other sites
