Search the Community
Showing results for tags 'triangle pivot'.
Found 1 result
-
On the 42" wide snow plow I procured with the 315-8 purchase other than the angle lever MIA so was the attachment point as well as the triangle pivot for the "wire", so I made some cardboard templates from my other snow plow frame and on a slow morning at work made all the missing parts, 1) the lever attachment point was made from 1/8" wall 2.5" sq tubing all cut on a band saw but could use a cut off wheel on an angle or die grinder, and the bolt hole drill was done with a hand drill 17/32" for a 1/2-13 nut welded on the backside (if making a new angle lever 3/8" or 7/16" would work as well), 2) the flat stock for the triangle pivot was made from 3/8"x1" with a 25/64" hole for a 3/8'' diameter shoulder bolt, then 3) the triangle pivot itself made from 14ga mild stainless steel with two 3/16" holes for the wire and a 25/64" hole for the pivot bolt, I'll update as I get these parts welded on and functioning as intended, Jeff.
