Search the Community
Showing results for tags 'rowcrop front end'.
Found 1 result
-
I have always thought a 953 would look good with a narrow front end and finally decided to take the plunge. The tractor is more maneuverable than with the wide front end and steers great. This 953, which I bought from @Mike'sHorseBarn, has the Ross Steering box but the same thing could be done with the later models with a Fan Gear 953/1054 or GT-14. The entire steering system bolts in place with holes that were already in the frame and the entire process is reversible if I were to decide to go back to stock. I started with a foot long piece of 3/4" round stock (an old steering shaft) and bent it at the center to fifteen degrees so the tires would be canted in like they are on an old farm tractor. Then I made a fixture to hold the axle in place while welding it to a piece of one inch round stock (an old one inch axle). I mounted the tires (Deestone 3.50-6) and wheels and they looked great! Shaft collars were added inside and holes for cotter keys were drilled on the outer edges of the wheels. The excess 3/4" axles were cut off. Once the axle and pivot were welded together it was on to the bearings and attachment fabrication. I used 3/16" X 4" flat bar and driller and tapped them to secure it to the frame. Having a 963 frame hanging around made the job easier. A four lug one inch trailer hub is used as the pivot point. With the bearings in place I could determine the location for the snap ring groove to hold everything in place and cut off the rest of the axle. Next a steering arm was fabricated and welded in place. It was a tight fit between the frame and tire. Now it was time to fabricate a drag link between the steering box and the steering arm. I bought the ball joints from Lowell https://www.wheelhorsepartsandmore.com/steering.html#!/3-8-x-7-16-Ball-Joint-2-Tie-Rod-MTD-Cub-Cadet-Toro/p/84788581/category=23548038 and fabricated the drag link from 5/8" round stock. I drilled and tapped the ends and used 7/16-20 threaded rod to join the ball joints to the link. This was a fun project and I am pleased with the way it came out. Looks a lot like the image on my tractor crossing sign.
- 37 replies
-
- 38
-
-
-
-
-
- narrow front end
- tricycle front end
- (and 1 more)
