I have a 314-8 with a 79360 snow thrower on it and I just picked up a 79253 48" plow. I was hoping to swap back and forth between the two as the snow conditions required. I currently want to switch from the blower to the plow but I've reached a snag. I've gotten to the point in the detachment procedure where I remove the pin clip holding the thrower's lift tube flag to the tractor's attachment lift control arm. I don't have a tractor lift and I'm laying on the floor in my unheated garage and when I lookup to see the pin and clip, I can barely see it at all. I can barely get a plier to it let alone, clamped on to it to pull the clip. Am I missing something? Is there a better way to reach this pin to remove the clip? I'm concerned that if I somehow get lucky and pull the clip off, I'll never be able to line up the lift tube flag and the control arm to get the pin back in the hole and the clip back on when I want to reattach the blower. Sorry about the lousy picture but it's very tight under the tractor and I was fumbling with a flash light and a smartphone with next to no clearance and the only way to see the pin clip was to take a photo almost straight up. The thing I circled in the overexposed area is the pin clip in question.