Search the Community
Showing results for tags 'idler'.
Found 4 results
-
I need a little part number help. I'm looking for the part number of the idler pulley that tensions the drive belt on my 857. The diagram shows the left side of the tractor. And I can't seem to locate the pulley on the parts drawing. The bearings have gone out on my tractor's idler.
-
Hi Guys, Had a random occurrence this week. Mowing along with my C85 eight speed in 1 low (grass was thick and wet), went to depress clutch and the drive belt jumped off the idler. I've had this tractor 3 years and it's been working great. The belt itself looks good except the top of it was a bit chewed up in a short section which I believe happened after it came off. I put the belt back on and continued to mow with no further issue. Any ideas as to why this would happen or adjustments I might need to make to prevent another incident? Thanks
-
I managed to get though last season with a "wobbly V belt idler pulley. Any Ideas on how to change this? I tried a puller which only bent the inner pulley. this is the bad one so nothing lost here. I guess I should change both. Am not sure I could use a press to take them off. I could cut them off but would rather do it the easy way if there is one. Any help would be great! Thanks
-
1990 520-H drive belt idler bracket/hood stand repair
resqdiver1 posted a topic in Restorations, Modifications, & Customizations
Hi All, I just picked up a 1990 520-h last week. While going through it and checking out a loose motion control linkage, I noticed the drive belt idler bracket had worn its hole to the base of the hood stand. It sounds like it is a pretty common occurrence. I was wondering if anyone has repaired this issue and if possible, could you post some pics? Also, like my 310-8, the rear of the hoodstand where the fender mount bolts has fatigued and cracked. Has anyone found a solution to this? Has anyone fabbed a more rugged hoodstand? Any and all help is appreciated! Cheers, John ps: I will post pics when the rain stops!