Search the Community
Showing results for tags 'gear drive deck'.
Found 2 results
-
While freshening up my RM-366 Gear Drive Deck for the new cutting season, I decided to do the @peter lena special - regreasing the 2 ball bearings in the PTO triple pulley. When I pulled the 6587 hitch shaft apart, I spotted 2 problems. The end of the pulley mount was short and angled, shown in the picture,when compared to the same part I fixed a while back for the 32" "Grease Comparison" deck I refurbushed last fall. This placed the inner edge of the triple pulley too close to the frame.. Also, the inner shoulder where the deck latch rides was severely worn. The solution was to make one repair sleeve out of 4140 that looks like a Top Hat. I had to get a little creative in the fixturing to cut down that deep. Machined both parts to give a .0015 press fit with red Loctite. Other end just required a 4140 sleeve. Cross drilled both ends for a grease port and fitting. Now the two former "womb-mates" ARE identical twins once more... Bill
-
Original Wheel Horse 1578 Belt pair USED and AS IS
rustyedge1 posted a classfied in Wheel Horse Sold Archive
These belts have been hanging in my garage since last used I believe there off a 754 I used to have. Bought them new and didn't use much. Don't know why I took them off. Some fraying on top in a few places from use, also don't know why but selling as is and photo'd. 20.00 shipped if you can use them. PM for PayPal info or questions. 16" ID approx.- 3 comments
-
- 1
-
- gear drive deck
- 754
-
(and 2 more)
Tagged with: