Search the Community
Showing results for tags 'drive'.
Found 6 results
-
My double pulley deck drive spindle seized up and shredded the shaft. Looking for a replacement assembly. My rig is 310-8, 1986ish. The deck is 36" rear discharge. Similar vintage but has no identifying tags. The drive spindle on this one is front and center, not the older version with the tall spindle near the back.
-
Hi Guys, Had a random occurrence this week. Mowing along with my C85 eight speed in 1 low (grass was thick and wet), went to depress clutch and the drive belt jumped off the idler. I've had this tractor 3 years and it's been working great. The belt itself looks good except the top of it was a bit chewed up in a short section which I believe happened after it came off. I put the belt back on and continued to mow with no further issue. Any ideas as to why this would happen or adjustments I might need to make to prevent another incident? Thanks
-
Cannot find info on proper drive belt size for my 48" mowing deck. I have what I believe is a 1990 416-H (41-160E01) with a 48" deck (xx-48SC02). All parts guidance on the various web pages recommend a 1/2"x103" belt for both 42" and 48" decks. However, this size is too long when I tried to replace. So rather than go trial and error with buying several belts and seeing what gets me lucky, I thought I'd first post a note here. Thanks for any constructive assistance.
-
My mule drive fell apart when I was plowing this winter and I grabbed all the parts I saw, but I'm not sure I got everything. Seems like there should be some spacers or washers to separate the pulleys. When it goes back together, I'll put a cotter pin through the nut.
-
Hi all, Just a little bit of information regarding replacement drive belts for the 227-5 in the UK if you are not buying OEM that might help someone in the future. The part number listed is 108427, which specs out as: Top width: 13mm Depth: 8mm Outside Length: 2235mm = 87.99" Sadly, a number of the first sites I found didn't specify that the 88" is the outside measurement so I having trusted their information and with the old belt still installed I just ordered A88s. Anyway, as I'm sure you all know, belts are sold based on the internal measurement therefore you would require A86! Actually now having spent some more time digging for information about the belt I have found sites specifying 88 as the outer diameter. including http://outdoorpowerinfo.com/, which seems like a pretty handy website. Regards Chris
-
I blew a drive belt on my 1983 C-145 hydro and the belt measured 82". I looked up the correct belt and have seen many different sizes called out. Is 5/8" x 81" correct? Is 5/8" x 81.5" correct? or Is 5/8" x 82" correct? I also saw 98" using the same wheelhorse number???? Any help would be appreciated, Thanks!
- 5 replies
-
- transmission
- drive
-
(and 1 more)
Tagged with: