Search the Community
Showing results for tags 'bushings'.
Found 3 results
-
I have a snowblower that has a bad bearing inside the auger on the chain side. Took it apart, and now I can't find a bearing like the one I need! One thing I need to know is if these parts are metric or American? If it is American, it is a 3/4" inside diameter, 1 5/8" outside diameter, 7/16" width. Anybody have a place they get them? Near Rochester, MN. It is a model 53321 snowblower I think as the model # plate is really scratched up.
-
ISO of hydro motion control lever bushings. These appear to be parts # 5666 (nylon) need 2, # 5983 (Nyliner) need 2, # MW2195 (bronze) need 1. Please PM me here. Thanks in advance.
-
I own a 314-8 Model 73400, Serial 4901829 that I began to disassemble in 2015 due to too much wobble/slop in the drive belt path. It appeared that the main culprits were the clutch cylinder and the idler pulley. After the drive belt broke I pulled it into my shop and disassembled for a closer inspection and repairs. Sadly, a life threatening health problem arose and surgery/treatments have prevented me from finishing this task until now. My problem now is that I cannot remember to save me how the fasteners/spacers(bushings)/washers (sequence) go in the clutch cylinder and belt idler. I've searched at this site and on the internet and cannot seem to locate diagrams/repair manuals with photos/etc. that will help me with this task. Can someone direct me to a source that will solve my problem? Suggestions? Any help will be greatly appreciated. Regards, Bob
