NOS crazy high lift blade

Looks like a blade from a snapper hi-vac...

appears to be the 37 sd for high lift for bagger system ????????

https://www.wheelhorseforum.com/search/?q=108846&quick=1

Appears to fit mostly 32" baggers but a few 37" listed. May be because the ipl's are shared. Scroll down the link.

https://www.partstree.com/parts/toro-108846/

Bat Wing blades......   Hard to come by. Used to help with leaf collectors on the 37" Baggers

Right side lift blade for the 200 and B-300 series bagger systems. Not sure if it will work with the 300 and 400 series 37" SD bagger, that number is 115084 but it might. Both are NLA and are very expensive if you find a new one.

This came as part of a package years ago with a bagger kit for a 300 series. I used a vacuum so I never used it. 

Maybe someone can find a use for it. 

8 hours ago, clueless said:

Right side lift blade for the 200 and B-300 series bagger systems. Not sure if it will work with the 300 and 400 series 37" SD bagger, that number is 115084 but it might. Both are NLA and are very expensive if you find a new one.

i was initially interested in the lift blade for my 37 sd mower with a bagger system -- however, when i looked up the parts number the  SET is # 109079 --- then i found the part number on my lift blade itself and it's # 115041 which is different # than your blade --- my blade is 18 1/2 inches long and appears the same except yours has the "oval" shaped spindle shaft hole -- 

i did not remove my spindle nut but i recall it's a round hole -- maybe tomorrow i will remove to compare the shaft hole - would like to buy yours but part # does not seem to match???????

Bill

here is the lift blade photo part number on the lift blade installed in my 37 sd mower with bagger

went on partstree and entered parts # ---- cross referenced your part number for lift blade # 108846 - - its listed for B Series and 200 Series tractors no listing i saw for 300 series

Well the length is correct at 18.5 inches. The center hole looks like a double D, but is much larger. I'm guessing a standard 3/4 shaft would require some type of adapter to fit correctly.